Presses

What does application of revitalizant provide:

    • Decreases ovality and taper of compressor cylinders and working motion of pneumatic hammers up to 0.15 mm
    • Decreases clearances and removes micro-wear of guides of hammers, presses and stamping units
    • Stabilizes operation of hydraulic systems
    • Prolongs service life by 1.5-2 times

    Applications:

    Compressors of pneumatic hammers

    Compressors of pneumatic hammers are treated withXADO Gel-revitalizant for compressors and bearingsin 3 stages without oil change in the amount of 1.5 ml for 1 L of operational oil for one treatment stage;

    Interval of accumulated operational time between stages makes 8-12 hours;

    Full treatment cycle makes not less than 450 hours of accumulated operational time of compressor, calculated from the first treatment stage.

    Cylinders of working motion hammers

    Treatment of cylinders of working motion hammers is carried out in 3 stages by introduction into lubrication system of cylinder-piston group of XADO Gel-revitalizant for compressors and bearings in the amount of 1.5 ml of gel to 1 L of lubrication oil for one treatment stage;

    Interval of accumulated operational time between stages makes 8-12 hours;

    Full treatment cycle of working motion cylinder makes not less than 450 hours of accumulated operational time of hammer, calculated from the first treatment stage.

    Hydraulic system of hydraulic hammers and presses

    See Hydraulic systems

    Guides of hammers, presses and stamping units

    Guides of hammers, presses and stamping units are treated with XADO Gel-revitalizant for compressors and bearings (industrial) by adding of necessary amount of gel in the amount of 9.0 ml for 1 L of operational oil for the whole treatment cycle.

    Full treatment cycle of guides makes not less than 700 hours of accumulated operational time of unit.